ford f150 power steering pump problems (With solutions)

Having a hard time with the darn noise from the power steering pump? Well, we all face it at some point of our trucking days. After a few days you might even experience rapid overheating, loss of power, and a lot more. You have just fallen in the Ford F150 Power steering pump problems category. 

Here, your steering pump fluid from the steering pump may leak out, you might have a horrible steering experience, and U-turns become especially tough. In some cases, you will have rapid overheating, pump cavitation, and the steering pump will fail to provide adequate pressure. 

Terrifying, right? Well, there’s a crack to every problem. Today, let’s dig into how you can fix a faulty power steering pump, else replace it as a whole.

6 Most common problems with ford f150 power steering pump (With solutions)

In A Hurry! Here’s The Easy Solutions At A Glace

F150 Power Steering Pump ProblemsPossible Solutions
Leaking Fluid1. Fix any leaks and refill power steering fluid
Making Noise1. Refill the fluid
2. Fix the belt
3. Clean any dirt and debris
4. Releasing the trapped air inside
5. Get the steering pump replaced
Harder to turn1. Fixing any leaks
2. Fluid pump replacement
3. Refill the power steering fluid
4. Fix the fuse
5. Clean any blockage
Losing Power/Failing To Provide Adequate Pressure1. Fix the fuse
2. Fixing the fluid level
3. Fixing any leaks
4. Power steering pump replacement
Pump May Be Cavitating/Swiftly moving/Failing to prime1. Fixing the steering 
2. Fixing any leaks
3. Replacing the belt
4. Pump replacement
5. Fixing the fuse

Pro-Tip: Most of the time, the power steering pump fluid level is too low. All you need is to get it up. However, if it doesn’t improve, you will find a solution in the fixing guide below. 

Why Is My Power Steering Pump Not Working

If the steering pump isn’t working, then it may be due to a low fluid level, loose steering pump belt, leaking, or the fuse went out. To fix it, you need to identify where the problem is coming from and then take the action.

Some new drivers may get their whole pump replaced, when the problem was in the mere low fluid level. 

ford f150 power steering pump problems: All Of Them Inside Out

If you’re stuck this far, you must really be in trouble. But hey, don’t worry. We got your back. If any of the following problems match with your bad steering experience, you will find a fix very soon.

If you’re stuck this far, you must really be in trouble. But hey, don’t worry. We got your back. If any of the following problems match with your bad steering experience, you will find a fix very soon. 

#1- Leaking Fluid

Over time, wear and tear can make the power steering pump fluid to leak. You should see an oil like fluid all over the pump seals or a break through the pump itself. Fixing it is pretty simple and most of the time, you won’t need to open the whole power steering pump. 

However, don’t forget to balance out the fluid level afterwards. 

#2- Making Noise

This is one of the most common problems you will face. A whining or grinding noise when turning the wheel may indicate a problem with the pump. Low hydraulic fluid levels, debris caught in the pump, or a worn out belt can cause this problem. 

In most cases, you will need to release the trapped air molecules trapped due to overheating of the pump.

#3- Harder to turn

Here, fluid leaks, a bad fuse, or dirt and debris is to blame. You need to get the fluid level in shape or get the shortened fuse fixed. If you find a leaked seal, then fix that first and then refill the hydraulic fluid.

#4- Losing Power/Failing To Provide Adequate Pressure

Sometimes, the power steering pump isn’t providing adequate pressure while steering. You may end up losing power after this. A leak in the fluid traversing path or a loose pump belt can be the reasons. Else, the pump can’t process enough power for the operation. 

#5- Overheating

Overheating is another potential problem with power steering pumps. With time and overuse, friction inside the pump can increase, causing a whining sound. An overheated pump can also cause fluid break down and a heck lot of steering problems. 

#6- Pump May Be Cavitating/Swiftly moving/Failing to prime

Generally, when the pump can’t move the fluid through it fast enough, the fluid starts bubbling up. This may cause the steering to go stiff, or the pump to fail completely. The pump will also fail to prime, which means it can’t build up enough pressure to work properly.

How To Fix A Ford F150 Steering Pump failure Problem

Fixing a Ford F-150 power steering pump problem is easy work. All you need is a few checks here and there and fix where necessary. Here are steps you need to follow: 

  • Open the power steering pump fluid container lead and balance the fluid if necessary. In most cases, the pump stays perfectly alright, but the fluid level goes below the average level. 
  • Inspect the belt for wear and tear. Replace a damaged belt if needed. 
  • Listen for any unusual noises from the power steering pump which the engine is on. 
  • If you hear noise, turn off the engine and turn the steering back and forth to see if there is any resistance. Too much resistance means your steering pump may be seized and you need a replacement. 
  • Now, check the hoses for any leaks, and fix them. You may need to replace the hoses if the condition is too bad. 

How To Replace/Change Ford F150 Power Steering Pump?

In some cases, you will need a complete replacement of the Ford F150 power steering pump. Here are all the steps you need to follow: 

  • Part your truck, turn off the engine, and place a block behind the rear tires for safety. 
  • Raise the hood and disconnect the negative and positive cable of the battery using a wrench or socket set. 
  • Now, locate the power steering pump on the driver’s side of the engine bay near where the serpentine is located. It will have a pulley on it. 
  • Loosen the power steering pump pulley bolts and remove the pulley belt with a wrench or socket set. 
  • Using a bigger pair of socket sets, loosen the power steering pump mounting bolts and remove the pump from the engine bay. 
  • Take the new power steering pump and line it up with the mounting holes. Tighten and secure the new pump properly.
  • Finally, reattach the power steering pump pulley and tighten the bolts to secure it. 

Note: Go through this YouTube video for a complete tutorial:

How Much Does A Ford F150 Replacement Cost?

There is no one-size-fits-all answer to this, as the cost of a Ford F150 replacement will vary depending on the specific model and year of the vehicle, as well as the location of the replacement.

However, as a general rule, a Ford F150 replacement will cost between $1,500 and $3,000. There are refurbished power steering pumps as well that will cost $700-$800 max. 

Frequently Asked Questions (FAQs)

Why Do Ford Power Steering Pumps Whine?

Ford power steering pumps whine because of the low fluid level. In the majority of cases, there is a leak, or you just didn’t refill the fluid that often. However, the steering pump may also get internally damaged over time, which causes the annoying sound. 

When The Power Steering Pump Goes Bad?

If you ever experience overheating, hard to turn, noise, or too much internal fluid leaks, you have to replace the power steering pump. In this case, the steering should fail to prime at maximum fluid level. 

Where Is The Ford F150 Power Steering Pump Located?

The Ford F150 power steering pump is located in the engine compartment on the right side of the engine (the driver’s side). Here you will see a serpentine as well. The power steering pump is mounted on the engine block, just behind the alternator. 

End Note

On average, you will hear a buzzing sound and experience harder to steer the wheel. After opening the hood, you may also see leaks and fluid all over. 

Anyhow, the fixes are simple. Fill the fluid valve and turn the engine on. If you find the steering isn’t working smoothly, you will need a replacement. Else, a few seals here and there will keep everything up and running. 

Who Worked on This?



I'm the guy responsible for ensuring that every blog post we publish is helpful for our reader.

Mahir Ahmed


I'm the guy responsible for ensuring honest, informative, accurate and helpful guide to the reader.

Leave a Comment